Custom Mandrel Bent Pipes for Cars, Trucks, & Boats
More Flow, More Horsepower
The purpose of a
mandrel pipe bender is to maintain the flow volume in the bends of
your exhaust
system by retaining the original diameter of the pipe - and
keep its flow volume and power.
Traditional "Press Benders" lose about 25% of the volume in the bend causing a restriction and limits the volume of exhaust traveling through the system. Therefore, a 2 1/2 inch pipe is virtually reduced to 2 inches.
How the Mandrel Bender Works
The mandrel portion of the mandrel pipe bender is a probe that remains in the bend as the pipe passes by, maintaining the volume. This procedure keeps continuity in exhaust flow which results in more horsepower.
Custom Made for Your Vehicle (not a Kit)
Ripley's Muffler & Brakes at 1960 & Kuykendahl in Houston, TX is one of the only shops in the country with the ability to custom mandrel bend pipe. A lot of shops can provide Mandrel Kits and Mandrel pieces but they don't always fit just right. A custom system is best because offers a continuous piece that is specifically made for your vehicle. When Mandrel pieces are used to build your system there may be joints that cause exhaust drag and negatively affect flow.
Custom mandrel bent systems are expensive for a couple reasons. Stainless steel pipe is required to do the neatest and cleanest job and Stainless steel is more expensive than the traditional aluminized.
The time required to build a mandrel bent exhaust system is more than the time required for a regular sytems since every bend must be 100% correct as there is no room for error. The Mandrel Bender does NOT allow for re-bends as does the Traditional Press Bender.
Call (281) 444-3885, contact us online, or come by to discuss custom mandrels and an exhaust system that best fits your needs.
Tommy Ripley V.P./G.M.